Extron Electronics BUC 102 - Manual (Page 7)

BUC 102 • Installation and Operation
Rack installation
The BUC 102 can be rack mounted using either the RSF 123
VersaTools 19" 1U rack shelf (Extron part #60-190-20), the RSB 123
basic VersaTools rack shelf (Extron part #60-604-20), the RSU 129
standard universal 1U rack shelf (Extron part #60-190-01), or the
RSB 129 1U basic rack shelf (Extron part #60-604-01). Figure 1
shows the VersaTools rack shelf, and Figure 2 shows a standard
rack shelf. On the standard rack shelf, there are eight mounting
locations at the front of the shelf or eight at the rear of the shelf.
VersaTools
Rack Shelf
Quarter Rack Width
False Front Face Plate
(2) 4-40 x 3/16"
screws
Eighth Rack Width
False Front Face Plate
DIS TR IBU TIO N A MP LIF IER
Figure 1 — Mounting the BUC 102 on a VersaTools
rack shelf
1. Remove the rubber feet from the unit, if previously
installed.
2. Mount the unit on the rack shelf, using two 4-40 x 3/16"
screws. These screws go into holes on the underside of the
unit near the left-front and right-rear corners.
Only products in the VersaTools line can be mounted on a
VersaTools rack shelf.
3. Install blank panels (included with Extron part #60-190-xx,
optional with Extron part #60-604-xx) or other units on the
rack shelf.
3