John Wood Commercial - ANED - Manual (Page 14)

Page 13
LIGHTING INSTRUCTIONS
FOR
ELECTRONIC IGNITION GAS MODELS
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance is equipped with an ignition device
which automatically lights the pilot, DO NOT TRY TO
LIGHT MANUALLY.
B. BEFORE LIGHTING, smell around the appliance area
for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
What Do You Do If You Smell Gas?
- Do not try to light any appliance.
- Do not touch any electrical switch: do not use any phone
in the building.
- Immediately call your gas supplier from a neighbour’s
phone. Follow the gas supplier’s instructions.
- If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to turn the gas control knob. Never
use tools. If the knob will not turn by hand, don’t try to
repair it, call a qualified service technician. Forcing or
attempting to repair may result in fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system, and any gas control which has been
under water.
Operating Instructions
1. Stop! Read the safety information above.
2. Turn off all electric power to appliance.
3. Remove thermostat access door.
4. Set thermostat to lowest setting.
5. This appliance is equipped with an ignition device which
automatically lights the pilot. DO NOT TRY TO LIGHT
THE PILOT MANUALLY.
6. Turn gas control know clock-wise to
“OFF”
7. Wait (5) five minutes to clear out any gas. If you then smell
gas, STOP. Follow section “B” in the safety information at
the head of this section. If you don’t smell gas, go to next
steps.
8. Turn gas control knob counter-clock-wise to
“ON”
9. Set thermostat to desired setting.
10. Replace insulation and thermostat access door.
11. Turn on all electric power to the appliance.
12. If the appliance will not operate, follow the instructions “TO
TURN OFF GAS TO THE APPLIANCE”, and call your service
technician or gas supplier.
To Turn Off Gas To Appliance
1. Turn off all power to appliance.
2. Remove thermostat access door.
3. Set the thermostat to lowest setting.
4. Turn gas control knob clock-wise to
“OFF”. Do not force.
5. Replace control access panel.
WARNING: IF YOU DO NOT FOLLOW THESE
INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION
MAY RESULT, CAUSING PROPERTY DAMAGE, PER-
SONAL INJURY OR LOSS OF LIFE.
GAS INLET
GAS OUTLET
GAS CONTROL
KNOB
(IN OFF
POSITION
IGNITES
CONNECTION
PILOT TUBE
CONNECTION