John Wood Takagi - 710 - Manual (Page 20)

20
With Remote Controller Installed: TM-RE30
(Optional)
1. Press the power ON/OFF button.
When ON,
green LED
is lit.
The temperature and the
time will be displayed on
the remote controller.
2. Set temperature. (Example 43°C (110°F))
Temperatures available in default mode
°C
38 40.5 43 46 49 52 55 57 60 63 65.5 68 71 74 77 79
°F
100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175
Temperatures available in High Temperature mode
°C
38 46 49 52 55 57 60 63 65.5 68 71 74 77 79 82 85
°F
100 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185
DO NOT set to 85°C (185°F) if you use your 710 in recircula-
tion system. Refer to pg. 29.
3. Open a hot water tap. Mix cold water with the hot if you
need.
4. Close the hot water tap.
Hot Water temperatures over 52°C (125°F)
can cause severe burns instantly or death
from scalding.
The outlet hot water temperature of
the water heater is factory set at 49°C
(120°F).
Feel the water temperature before bath-
ing or showering. •
•
To change the remote controller’s mode from Default Mode
to High Temperature Mode, please follow the procedures
below (the remote controller must be installed prior to oper-
ating these procedures):
DO NOT set to 185°C (85ºF) if you use your
710 water heater in a recirculation system.
This will cause damage to the heater and
void the warranty.
1. Turn off power to the remote controller by pressing the
“ON/OFF" button.
Lamp is OFF to indicate that power is off
2. Simultaneously press and hold both the “HOT” and
“COLD” buttons for
at least five seconds.
And then make sure
“1” (or “0”) is dis-
played on remote
controller. “1” is dis-
played for single
units, “0” is dis-
played for Easy-
Link / Multi-
Systems.
3. Press the “TIME” button. Make sure "oFF" and "F1" are
displayed on
remote controller.