Xylem PH3210 FIELD PH METER - Manual (Page 17)

pH 3210 Operation
17 ba75793e02 12/2008
4.2.2 Navigation
Measured value display In the measured value display, you can
z open the respective measuring menu with (short keystroke).
z open the Storage & config menu with the sensor-independent
settings by pressing
_
> (long keystroke, approx. 2 s on ).
z change the display in the selected measuring window
(e. g. pH
<−> mV) by pressing .
Menus and dialogs The menus for settings and dialogs in procedures contain further
submenus. The selection is made with the <
▲><▼> keys. The current
selection is displayed with a frame.
z Submenus
The name of the submenu is displayed at the upper edge of the
frame. Submenus are opened by confirming with .
Example:
z Settings
Settings are indicated by a colon. The current setting is displayed on
the right-hand side. The setting mode is opened with .
Subsequently, the setting can be changed with <
▲><▼> and
. Example:
General
Measurement
Interface
Clock
Service information
Reset
System
22.09.2008
08:00
Back
Language: Deutsch
Beep : Off
Illumination : On
Contrast : 50 %
Switchoff time : 1 h
General
22.09.2008
08:00
Back