Xylem H-3551 - Manual (Page 27)

H-3551
SDI-12 Command and Response Protocol 5-9
5.8 Change Sensor Address Command
The Change Sensor Address Command allows the sensor address to be changed. The address is
stored in non-volatile Flash memory within the sensor. The H-3551 will not respond if the
command was invalid, the address was out of range, or the Flash programming operation failed.
Command Response Description
"aAn! "n" Change sensor address
Where:
a is the current (old) sensor address ("0-9", "A-Z", "a-z", "*", "?"). An ASCII "*"
may be used as a "wild card" address if the current address is unknown and only
one sensor is connected to the bus.
A is an upper-case ASCII character.
n is the new sensor address to be programmed ("0-9", "A-Z").
NOTE: To verify the new address use the "Identify Command."
Example of a "Change Sensor Address" command:
Command Response Description
"aA2!" "2" Change sensor address to "2"