YSI IQ SensorNet TetraCon Sensor 700 IQ (SW) - Manual (Page 29)

TetraCon
®
700 IQ (SW) Indexes
9 - 1 ba76018e01 01/2012
9 Indexes
9.1 Explanation of the messages
This chapter contains a list of all the message codes and related
message texts that can occur in the log book of the IQ S
ENSOR N ET
system for the TetraCon
®
700 IQ (SW) sensor.
Note
Information on the contents and structure of the log book, and how to
call it up, is given in the L
OG BOOK chapter of the IQ S ENSOR N ET
system operating manual.
9.1.1 Error messages
9.2 Status info
The status info is a coded piece of information on the current status of
a sensor. Each sensor sends this status info to the controller. The
status info of sensors consists of 32 bits, each of which can have the
value 0 or 1.
Status info,
general structure
The bits 0 - 15 are reserved for general information.
The bits 16 - 21 are reserved for internal service information.
Message code Message text
EA13xx Meas. range exceeded or undercut
* Check process
* Select other meas. range
EA23xx Sensor temperature too high!
* Check process and application
EA33xx Sensor temperature too low!
* Check process and application
ES13xx Component hardware defective
* Contact service
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 (general)
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 (internal)
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31