YSI IQ SensorNet TetraCon Sensor 700 IQ (SW) - Manual (Page 15)

TetraCon
®
700 IQ (SW) Measuring / Operation
4 - 1 ba76018e01 01/2012
4 Measuring / Operation
4.1 Measuring
Warning
Contact with the sample can lead to danger to the user!
Depending on the type of sample, suitable protective measures
must be taken (protective clothing, protective goggles, etc.).
Note
Please make sure that the sensor is surrounded by a gap of at least 5
cm at the base and sides (boundary fields) when measuring at the
electrodes. If the gap is less than that, the cell constant changes. This
leads to incorrect measurement results. If the gap cannot be
maintained, e.g. in narrow pipes, the cell constant can be adjusted to
suit the installation conditions (see section 4.2.2).
Fig. 4-1 Distance of the sensor from the edge
1 Immerse the sensor in the measuring medium.
2 The measured value is immediately available.