Xylem Aquontroller - Manual (Page 48)

en en en en
48
Parameter list of the Extended Menù Parameter list of the Extended Menù Parameter list of the Extended Menù Parameter list of the Extended Menù
Rif. Rif. Rif. Rif. Parameter Parameter Parameter Parameter Model Model Model Model
Read Read Read Read
(R) (R) (R) (R)
Write Write Write Write
(RW) (RW) (RW) (RW)
Unit Unit Unit Unit Min Min Min Min Max Max Max Max
Defaul Defaul Defaul Defaul
tttt
Description Description Description Description
00 Password
MMA
MMW
00066
(0074
0)
Password for changing parameters in the Extended Menu - for reading only no
password is needed. If password was set wrong the message: “???password=0…” will
be displayed and values were not changed.
01 fnom. motor
MMA
MMW
RW Hz 39.99 99.99 45 Rated frequency of motor. This value f(nom) is indicated on the motor rating plate.
02 Language
MMA
MMW
RW Italian Language selection.
03 f (Umax)
MMA
MMW
RW Hz 29.99 99.99 50 Frequency applied to the motor to obtain Umax (e.g.: set 50 to obtain 230V at 50 Hz)
04* Configuration
MMA
MMW
RW N. 0 2 1 This parameter must be set to default value “1”
05 Input Buffer
MMA
MMW
R N. 0 255 Varie Read digital inputs
06 Ramp 1 Acceler.
MMA
MMW
RW sec 0.7 5 1.5
Time required for the output frequency applied to the motor to pass from zero to
maximum frequency.
07 Ramp 2 Deceler.
MMA
MMW
RW sec 0.7 5 1.5
Time required for the output frequency applied to the motor to pass from maximum
frequency to zero.
08 JOG Frequency
MMA
MMW
RW Hz 0 Par.(1) 50
Sets the frequency applied to the motor in the manual mode. In the operating mode
(para 28) it must =0
09 Drive State
MMA
MMW
R 0 0 107 Varie
Coded number, used to display driver state information. Examples: 0=off, 1=motor
accelerating, 2=constant speed, 3=deceleration, 4=stopping, 5=stopped, 100=over
current FF. 101=over current FT, 102=under voltage, 103=over voltage, 104=over
temperature, 105=Short circuit shut-down, 106=protected I2T, 107=motor
disconnected.
10
MMA
MMW
R 0 0 104 Varie
Coded number, used to display hydraulic system information and measurements.
0=Disabled, 1=Stop, 2=Run, 100=No water, 101=Insufficient pressure, 102=Pressure
sensor fault, 103=Water hammering.
11 fmin /MotorStop MMA RW Hz 0 Par.(1) 10
Minimum permitted motor frequency. The driver shuts down below this value. Active if
different from 0.
12 Drive ResetTime MMA RW sec 0.1 100 10 Delay between one motor start and the next following a driver fault. Driver 10X states