Xylem Aquontroller User Manual
Page 44

en
en
en
en
44
Navigation, changing parameters and saving Rapid Installation Menu
Navigation, changing parameters and saving Rapid Installation Menu
Navigation, changing parameters and saving Rapid Installation Menu
Navigation, changing parameters and saving Rapid Installation Menu
Right after connecting the AQUONTROLLER to the power supply version and production date is displayed
shortely.
AQUONTROLLER
*MMW07* 01/01/10
During the next 30 seconds the rapid installation menu can be entered by pressing +. To come back to
this point disconnect plug and wait until the display disappears, then connect again.
Only if the AQUONTROLLER was already set up you might skip the rapid installation menu by pressing
ENTER. After 30 seconds the menu is left and the AQUONTROLLER will start automatically if already set
up.
Installation (+)
Start (ENTER)
Press ENTER to start the drive with the default parameters and the display shows values pressure of
system and the operating frequency of the motor.
Press + button to proceed with the rapid installation process.
Press + or - to change the language. Press ENTER key for three seconds to save the change.
The rescue is confirmed by a specific message.
Language
Italian
Press right arrow key to display the next parameter. Press + or - to change the value of motor current.
Press ENTER key for three seconds to save the change. The rescue is confirmed by a specific message.
Nom MotorCurrent
4,5 Ampere
Press right arrow key to display the next parameter. Press + or - to change the par value of the desired
pressure in the system. Press ENTER key for three seconds to save the change. The rescue is confirmed by
a specific message.
Nominal Value
4.00 bar
Press right arrow key to display the next parameter. Press + or - to change the parameter of Auto-Start.
Press ENTER key for three seconds to save the change. The rescue is confirmed by a specific message.
Auto- Start
ON
Press right arrow key to display the next parameter. Press ENTER key for three seconds to save the
change. The rescue is confirmed by a specific message.
Save & Exit
With ENTER
Subsequently, AQUONTROLLER
starts
and the
display shows the
values
of
system pressure
and
the
operating frequency
of the motor.
3,50 bar 45,00 Hz
Active……………..