Bell & Gossett 6 71 075 115A LS Condensate Removal Pump - Manual (Page 3)

Included Items
Your LS Condensate Pump should include the following items. See Fig.4 below.
(a) (b) (c) (d)
Optional items that may be needed for pump installation: Hose clamps
Safety Requirements
Prior to starting the installation process, please observe and understand the following safety requirements. Failure to
understand these instructions could result in personal injury, death, and/or property damage.
Mechanical Safety
WARNING: - Excessive System Pressure Hazard - The maximum working pressure of the pump is listed on
the nameplate - Do Not Exceed This Pressure. Failure to follow these instructions could result in serious
personal injury, death and/or property damage.
WARNING: - Excessive Pressure Hazard Volumetric Expansion - The heating of water and other fluids causes
volumetric expansion. The associated forces may cause failure of system components and the release of high
temperature fluids. This can be prevented by installing property sized and located compression tanks and
pressure relief valves. Failure to follow these instructions could result in serious personal injury, death and/or
property damage.
WARNING: - Extreme Temperature Hazard - If the pump, motor or piping are operating at extremely high or
low temperature, guarding or insulation is required. Failure to follow these instructions could result in serious
personal injury, death and/or property damage.
Thermal Safety
WARNING: - Electrical Grounding Hazard - Adequate electrical grounding is required for the safe operation
of B&G Pumps. Connect the ground wire to the ground terminal in the wiring compartment. Failure to follow
these instructions could result in serious personal injury, death and/or property damage.
WARNING: - Risk of Electric Shock - Do not install this pump in swimming pool or marine areas. Failure to
follow these instructions could result in serious personal injury, death and/or property damage.
Electrical Safety
WARNING: - Electrical Shock Hazard - Electrical connections are to be made by a qualified electrician in
accordance with all applicable codes, ordinances and good practices. Failure to follow these instructions could
result in serious personal injury, death and/or property damage.
a. LS Condensate Pump unit
b. Mounting bracket (designed for rear wall
or left side wall mounting)
c. Pressure hose connection kit
d. Pressure hose (19ft.)
Installation
The LS Condensate Pump must be installed in dry rooms (frost proof and where the air temperature does not exceed
140°F (60°C) using the installation bracket provided. It is mounted to the wall below the condensate supply outlet. En-
sure that the pump is mounted horizontally. If floor-mounted, ensure that it is in a stable position We recommend that
you also secure it to the nearest wall.
WARNING: The unit may not be installed in areas where there is a danger of explosion!
After a suitable location for installation has been determined. Follow these steps and pre-cautions continued on the
next page: