Acer Altos G301 - Manual (Page 61)

49
Introduction
Most systems are already configured by the manufacturer or the
dealer. There is no need to run Setup when starting the computer
unless you get a Run Setup message.
The Setup program loads configuration values into the battery-backed
nonvolatile memory called CMOS RAM. This memory area is not part of
the system RAM.
Note: If you repeatedly receive Run Setup messages, the battery
may be bad. In this case, the system cannot retain configuration
values in CMOS. Ask a qualified technician for assistance.
Before you run Setup, make sure that you have saved all open files. The
system reboots immediately after you exit Setup.
bb411/cppl!!Qbhf!5:!!Uivstebz-!Kbovbsz!34-!3114!!3;3:!QN