Acer Veriton S6610G - Manual (Page 26)

4 Frequently asked questions 16
English
Frequently asked questions
The following questions indicate possible situations that may arise during the
use of your computer and each is followed by easy answers and solutions.
I pressed the power switch but the system did not boot up.
Check the LED located above the power switch.
If the LED is not lit, no power is being applied to the system. Try the following:
•
Check if the voltage selector switch located on the rear panel of the
computer is set to the correct voltage.
• Check if you properly plugged the power cable into an electrical outlet.
• If you are using a power strip, make sure it is plugged in and
turned on.
If the LED is lit, check the following:
•
Is a nonbootable (nonsystem) disc in a drive? If yes, remove or replace it
with a system disc and press + + to restart your
computer.
Nothing appears on the screen.
• Check that the cable is correctly attached to the computer and the
monitor.
Your computer's power management function automatically blanks the screen
to save power. Just press any key to turn the display back on.
If pressing a key does not work, you can restart your computer. If restarting
your computer does not work, contact your dealer or technical support center
for assistance.
The printer does not work.
Do the following:
•
Make sure the printer is connected to a power outlet and that it is
turned on.
• Make sure the printer cable is connected securely to the correct ports on
the computer and the printer.
• For additional information concerning the printer, refer to the printer's
documentation.