C2G 32568 UKV-048OSD_088OSD_0168OSD - Manual (Page 19)

UKV-048OSD/088OSD/0168OSD Rackmount KVM Switch User Manual Rev. 1.8 July 2004
All the available hotkey commands are summarized in the following table for your
convenience.
For hotkey command, you should use the number keys on the upper row of the keyboard
instead of the number pad, which is invalid for hotkey commands.
Command Hotkeys Reference
Select PC
ScrLk + ScrLk + (ab) + (yz) 1
(ab) = 2-digit bank number (yz)= 2-digit channel number
See Page 22
Next lower channel ScrLk + ScrLk + ↑ (arrow up) See Page 23
Next higher channel ScrLk + ScrLk + ↓ (arrow down) See Page 23
Next lower bank
ScrLk + ScrLk + PgUp
See Page 23
Next higher bank ScrLk + ScrLk + PgDn
See Page 24
Autoscan Beep Sound
On/Off
ScrLk + ScrLk + B
See Page 24
Reflash EEPROM ScrLk + ScrLk + R See Page 24
Find PC by Name
ScrLk + ScrLk + F
See Page 25
Change PC Name
--
See Page 26
Reset KVM
ScrLk + ScrLk + End
See Page 26
Show OSD Menu ScrLk + ScrLk + Space Bar
See Page 26
Autoscan ScrLk + ScrLk + S
See Page 26
Stop Autoscan (Any key on keyboard)
See Page 26
Autoscan Delay Time -- See Page 27
Password Config -- See Page 27
Password Change -- See Page 28
Notes:
1 Note that a, b, y and z each denotes a number key. (ab) = 01 ~ 16 ; (yz) = 01 ~ 04 or 01 ~ 08 or 01 ~ 16.
Table 3-1 Summary for Hotkey Sequences
Page 19
Chapter 3 Operation