C2G 52041 TruLink VGA and PS_2 KVM - Manual (Page 8)

7
Hardware Setup
Front View
1. Port Selection Switches
• Press a switch to give the KVM
focus to the computer attached to
its corresponding port.
• Pressing Buttons 1 and 2
simultaneously for more than 3
seconds starts Auto Scan Mode
(see p. 13).
• While in Auto Scan Mode, pressing
any button exits Auto Scan Mode
and switches the KVM focus to its
corresponding port.
2. Port LEDs
• The Port LEDs are built into the Port Selection
Switches. A lit LED indicates that its corresponding
Port is the one that has the KVM focus.
• Depending on the Port's status, the LED may flash
according to a specific pattern (see p. 11 for
details).