C2G 52041 TruLink VGA and PS_2 KVM - Manual (Page 6)

5
Safety Instructions
Read all of these instructions. Save them for future reference.
Follow all warnings and instructions marked on the device.
• Do not place the device on any unstable surface (cart,
stand, table, etc.). If the device falls, serious damage
will result.
• Do not use the device near water.
• Do not place the device near, or over, radiators or heat
registers.
• The device cabinet is provided with slots and openings
to allow for adequate ventilation. To ensure reliable
operation, and to protect against overheating, these
openings must never be blocked or covered.
• The device should never be placed on a soft surface
(bed, sofa, rug, etc.) as this will block its ventilation
openings. Likewise, the device should not be placed in
a built in enclosure unless adequate ventilation has
been provided.
• Never spill liquid of any kind on the device.
• Unplug the device from the wall outlet before cleaning.
Do not use liquid or aerosol cleaners. Use a damp cloth
for cleaning.
• The device should be operated from the type of power
source indicated on the marking label. If you are not
sure of the type of power available, consult your dealer
or local power company.
• Do not allow anything to rest on the power cord or
cables. Route the power cord and cables so that they
cannot be stepped on or tripped over.
• If an extension cord is used with this device make sure
that the total of the ampere ratings of all products used
on this cord does not exceed the extension cord
ampere rating. Make sure that the total of all products
plugged into the wall outlet does not exceed 15
amperes.
• To help protect your system from sudden, transient
increases and decreases in electrical power, use a
surge suppressor, line conditioner, or uninterruptible
power supply (UPS).