AVSL 152.763 THE WORM User Manual

Page 16

152.765UK User Manual

Troubleshooting

No power
or output

Check that mains power is connected correctly
Check that power indicator is on and mains fuse is OK
If fuse continually blows, refer to qualified service personnel

Power OK
but no output

Check that laser aperture is not covered
Ensure safety key switch is set to “on”
Check remote power connector if in use
If ambient temperature is low, wait up to 30 mins for warm-up
Check if set to sound-activated without any sound to trigger
Check if in DMX mode without DMX signal

Laser output
very dim

If ambient temperature is low, wait up to 30 mins for warm-up
If necessary, carefully clean the scanner mirror with alcohol
If necessary, carefully clean the aperture glass with alcohol
Check DMX settings – reduce strobe effects if necessary
Reduce distance to projected surface

Laser on
but no movement

Check if set to sound-activated without any sound to trigger
Check if in DMX mode without motion command from DMX
Adjust DMX controls manually to check motion commands

No response
to DMX

Check DMX start address is set correctly
Check DMX leads, connections and polarity are OK
Check DMX leads are not running close to high voltage cables
Test DMX with alternative controller

Important: This product conformed to Laser & LED Safety standard BSEN60825-1 2007 incorporating

corrigendum 2008

Disposal:

The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or

Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.

The goods must be disposed of according to your local council guidelines.

Errors and omissions excepted.