Armasight NSGSPARKX1CCIC1 SPARK-X Night Vision Goggles User Manual

Page 5

• Do not expose the device to moisture or extreme temperatures.
• Do not touch the lenses. Clean optical parts with a clean, soft cloth, and use only professional

lens cleaners designed for use with optics.
• Do not forget to turn the device OFF during the periods of non-operation.
• Do not forget to remove the battery from the battery compartment if the device is to be

stored for more than 3 days.

NOTES

take into consideration the following information and restrictions in order to avoid damag-

ing the device and to ensure a long service life and failure-free operation:
• Performance of the device in nighttime conditions depends on the level of ambient light in

the environment. Some light (moonlight, starlight, etc.) is required for the device to provide an

image.
• Ambient light level is reduced by the presence of clouds, shade, or objects that block natural

light (buildings, trees, etc.).
• The device loses its effectiveness when operated in shadowed areas.
• The effectiveness of the device is adversely affected by weather conditions such as rain,

snow, sleet, or fog, and environmental conditions such as smoke or dust.
• The device resolution level is reduced in environments with very low light sources. The vis-

ibility will degrade significantly under starlit conditions, particularly in low contrast environ-

ments such as deserts, large areas of uniform vegetation, etc.

BATTERY INSTALLATION

1) Unscrew the battery compartment cap on the back side of the goggles body.
2) Insert the CR123A battery into the battery compartment in accordance with polarity markings.
3) Screw the cap onto the place.

ATTACHING THE SPARK-X TO A HEAD MOUNT

To attach your Spark-X to a head mount perform the following steps:
1) Loosen the screw (A), press the button (B), and put the bin-

ocular rail into the headset socket (C).
2) Put the head mount, with the Spark-X attached, on your

head.
3) Loosen the screw (A) and perform an eye relief adjustment

by moving the binocular on the rail.
4) The head mount intended for use with the Spark-X is fitted

with a flip-up mechanism. Press the button (D) from the head

mount side and lift the binocular to the top position.
5) To return the unit back to the operating position, press the

button (D) again and lower the binocular.
6) Press the button (E) and move the binocular on the rail (F)

to reach the most comfortable position for observation.