Armasight NRWNEMESI42GDS1 Nemesis4x GEN 2+ SD Night vision rifle scope - Manual (Page 6)

6
3. OPERATIOn InSTRUCTIOnS
COnTROLS
The Armasight Nemesis features simple, easy-to-operate, one-button controls and adjustments.
To turn on the sight, push the operating button once.
To turn off the sight, push the operating button again.
To adjust the reticle brightness, do the following:
1) Look into the eyepiece.
2) Turn the sight on. Press the operating button and hold it down. As long as the button is held down,
you will be able to see the reticle brightness through the viewfinder, and it will increase gradually. After
you’ve reached your desired level of brightness, release the button.
3) To reduce the brightness level of the reticle, hold down the operating button second time. The
brightness will slowly decrease as you do so.
FOCUSIng yOUR DEVICE
To focus the Nemesis, turn the diopter ring clockwise until it stops. Then, while looking through the
eyepiece, aim the sight towards an object in the distance and begin slowly rotating the diopter ring in
a counterclockwise direction until the image becomes sharp and clear.
You sight has the ability to focus when presented with both long-range and short-range distances.
Focus the front lens by rotating the knob until the image becomes clear.
nOTE:
Remember that, if you are operating your Nemesis in daylight, be sure that the protective lens
cover is securely fitted over the objective lens, before you begin adjusting the diopter.
SETTIng-UP PROCEDURES
To check device’s operation in daylight or in an illuminated room, observe the following procedures:
1) Verify that the battery is inserted into the battery compartment in accordance with the polarity
markings on the body of the sight.
2) Verify that the objective lens is securely closed.
3) Without removing the protective caps, activate the unit by pushing the operating button. While
looking through the eyepiece, observe the scene. Verify that the green light indicating correct IIT op-
eration is on.
4) Adjust the eyepiece’s diopter ring and lens focus until the eyepieces image becomes clear and
sharp.
5) Turn the unit off by pushing the operating button. The green glow will disappear from the eye-
piece.