Armasight NRWNEMESI42GDS1 Nemesis4x GEN 2+ SD Night vision rifle scope - Manual (Page 5)

5
BATTERy InSTALLATIOn
1) Unscrew the battery compartment cap.
2) Insert the battery into the battery compartment, fol-
lowing the polarity order marked on the compartment
for reference. Remember that the Nemesis requires a
single 3 Volt lithium CR123A battery.
3) Screw the battery cap back into place.
mOUnTIng THE wEAPOn
1) Loosen the screws on the 7/8” weaver mount of the Nemesis.
2) Place the sight on the weaver base of the firearm.
3) Re-tighten the screws.
nOTE:
After firing a round, the screws may need to be re-tightened.
mOUnT SySTEm
To provide you with greater flexibility when mounting your Nemesis on the Mount System, we have
installed a small rail with a fixing projection on the base of the mount bracket, together with the de-
termined weaver rail indents that are used for mounting. The mount bracket has two grooves that can
accept this rail. You can shift the mounting position of your Nemesis by an extra 1/3 of an inch by simply
turning the rail around.
To add additional inches to the Nemesis weapon
mount, please follow the instructions below:
1) Remove the two screws that attach the rail to the
mounting bracket.
2) Remove the rail from the groove.
3) Turn the rail around.
4) Put the rail into the other groove.
5) Re-tighten the two screws on the rail.
nOTE:
Occasionally, you may find that the rail does not slide out easily. If this occurs, rotate one of the
removed screws into the threaded aperture in the center of the fixing projection. This will work
as a jack and release the rail out of the groove.
grOOves
rail With a
fixing prOjectiOn
screWs
mOunting
system
battery
installatiOn