Asus WL-300g - Manual (Page 64)

6. Appendix
64 ASUS 802.11g Access Point
Chapter 6 - Safety Statements
FCC Radio Frequency Interference Requirements
MPE Statement: Your device contains a low power transmitter. When
device is transmitted it sends out Radio Frequency (RF) signal.
This device is restricted to INDOOR USE due to its operation in the 5.15
to 5.25GHz frequency range. FCC requires this product to be used indoors
for the frequency range 5.15 to 5.25GHz to reduce the potential for harmful
interference to co-channel of the Mobile Satellite Systems.
High power radars are allocated as primary user of the 5.25 to 5.35GHz
and 5.65 to 5.85GHz bands. These radar stations can cause interference
with and / or damage this device.
FCC RF Exposure Guidelines (Access Points)
This Wireless LAN radio device has been evaluated under FCC Bulletin
OET 65C and found compliant to the requirements as set forth in CFR 47
Sections 2.1091, 2.1093, and 15.247(b)(4) addressing RF Exposure from
radio frequency devices. The radiation output power of this Wireless LAN
device is far below the FCC radio frequency exposure limits. Nevertheless,
this device shall be used in such a manner that the potential for human
contact during normal operation – as a mobile or portable device but use in
a body-worn way is strictly prohibit. When using this device, a certain
separation distance between antenna and nearby persons has to be kept to
ensure RF exposure compliance. In order to comply with the RF exposure
limits established in the ANSI C95.1 standards, Access Point equipment
should be installed and operated with minimum distance [20cm] between
the radiator and your body. Use only with supplied antenna. Unauthorized
antenna, modification, or attachments could damage the transmitter and
may violate FCC regulations.
CAUTION: Any changes or modifications not expressly approved
in this manual could void your authorization to use this device.