Asus WL-300g - Manual (Page 45)

3. Software
ASUS 802.11g Access Point 45
Chapter 3 - Software Configuration
Web (Common)
System Setup
Click this item on the menu to reveal a sub menu. Follow the
instructions to setup the ASUS 802.11g AP. Tips are given
when you move your cursor over each item.
Factory Default
Restoring Factory Default Settings
Web Manager
You can reset all settings to their factory defaults through the web manager
using the “Factory Default” page in “Advanced Setup”. Click the Restore
button and wait about 30 seconds before trying to access the ASUS 802.11g
AP.
Hardware
You can reset all settings to their factory defaults manually by pushing the
“Restore” button in a hole on the back of the ASUS 802.11g AP while it is
ON. Use a pen or straightened paper clip to hold the “Restore” button
depressed over 5 seconds until the power LED on the front of the ASUS
802.11g AP starts blinking.
Note: You will be notified when factory default settings are restored
while using the web manager.