Asus M3A78-CM - Manual (Page 48)

2-10 ASUS M3A78-CM
Type [Auto]
Selects the type of IDE drive. Setting to [Auto] allows automatic selection of the appropriate
IDE device type. Select [CDROM] if you are specifically configuring a CD-ROM drive. Select
[ARMD] (ATAPI Removable Media Device) if your device is either a ZIP, LS-120, or MO drive.
Configuration options: [Not Installed] [Auto] [CDROM] [ARMD]
This item does not appear when you select the SATA 1/2/3/4/5/6 devices.
LBA/Large Mode [Auto]
Enables or disables the LBA mode. Setting to [Auto] enables the LBA mode if the device
supports this mode, and if the device was not previously formatted with LBA mode disabled.
Configuration options: [Disabled] [Auto]
Block (Multi-Sector Transfer) M [Auto]
Enables or disables data multi-sectors transfers. When set to [Auto], the data transfer from
and to the device occurs multiple sectors at a time if the device supports multi-sector transfer
feature. When set to [Disabled], the data transfer from and to the device occurs one sector
at a time. Configuration options: [Disabled] [Auto]
PIO Mode [Auto]
Selects the PIO mode. Configuration options: [Auto] [0] [1] [2] [3] [4]
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer. Configuration options: [Disabled] [Enabled]
2.3.5 SATA Configuration
This menu allows you to configure the SATA devices.
OnChip SATA Channel [Enabled]
Enables or disables the OnChip SATA Channel. Configuration options: [Enabled] [Disabled]
OnChip SATA Type [SATA]
Allows you to select the SATA type. Configuration options: [SATA] [RAID] [AHCI]
SATA IDE Combined Mode [Enabled]
Enables or disables SATA IDE Combined Mode. Configuration options: [Disabled] [Enabled]
When the SATA IDE Combined Mode is set to [Disabled], SATA ports 1-4 work well in all
the three modes, while SATA ports 5-6 only work at [RAID] or [AHCI] mode.