Asus P5P41T/USB3 - Manual (Page 49)

ASUS P5P41T/USB3 2-11
Selecting a very high DRAM frequency may cause the system to become unstable! If this
happens, revert to the default setting.
The following table shows the DRAM Frequency options that appear when the FSB value is
1333, 1066, and 800.
Memory Voltage [Auto]
Allows you to adjust Memory Over voltage and each step is 10mV.
NB Voltage [Auto]
Allows you to set the Northbridge voltage. The values range from 1.12500V to 1.51875V with
a 0.00625V increment. Key in the value directly or use +/- to adjust the voltage.
Configuration options: [Auto]
VTT Voltage [Auto]
Allows you to set the VTT voltage. The values range from 1.20000V to 1.59375V with a
0.00625V increment. Key in the value directly or use +/- to adjust the voltage.
Configuration options: [Auto]
CPU Over Voltage [Auto]
Allows you to set the CPU over voltage. The values range from 0.0100V to 0.6300V with a
0.0100V increment. Key in the value directly or use +/- to adjust the voltage.
Configuration options: [Auto]
SB 1.5V Voltage [1.5V]
Allows you to select the South Bridge voltage. Configuration options: [1.5V] [1.6V]
Auto PSI [Enabled]
Allows you to enable or disable the Auto PSI mode.
Configuration options: [Disabled] [Enabled]
Start auto tuning
Press [Enter] to start auto tuning. It takes around five minutes and the system will reboot for
several times. After auto tuning, C-State is disabled.
FSB
DRAM Frequency
Auto 800MHz 960MHz 1000MHz 1067MHz 1100MHz 1333MHz
1333 v v v v
1066 v v v
800 v v