Hardware setup – Asus P2B-N User Manual

Page 27

ASUS P2B-N User’s Manual

3. HARDWARE SETUP

CPU

3. H/W SETUP

3. Insert the SECC2/SECC/SEPP

SECC with Pentium

II only: Push the SECC’s two locks inward until you hear

a click (the picture in step 2 shows the locks in the outward position and inward in
the picture below).

With the heatsink facing the motherboard’s chipset, push the SECC, SECC2, or
SEPP gently but firmly into the Slot 1 connector until it is fully inserted.

4. Secure the SECC2/SECC/SEPP

Secure the SECC2/SECC/SEPP in place by pushing the SECC2/SECC/SEPP
until it is firmly seated on the Slot 1 connector.

SECC with Pentium

II only: The SECC locks should be outward when se-

cured so that the lock shows through the retention mechanism’s lock holes.

SECC2/SEPP

Push lock inward

SECC

SECC2/SEPP

CPU fan cable to
fan connector

CPU fan
cable to fan
connector

Lock hole

WARNING!

Make sure the heatsink is mounted tightly against the SECC2, SECC,

or SEPP; otherwise, the CPU will overheat. You may install an auxiliary fan to
provide adequate circulation across the processor’s passive heatsink.

Lock hole