Asus P7H55/USB3 - Manual (Page 50)

2-10 Chapter 2: BIOS information
2.4.4 Intel(R) SpeedStep(TM) Tech [Enabled]
When set to [Disabled], the CPU runs at its default speed. When set to [Enabled], the CPU
speed is controlled by the operating system. Configuration options: [Disabled] [Enabled]
2.4.5 Intel(R) TurboMode Tech [Enabled]
This item appears only if you set the CPU Ratio Setting item to [Auto]. Turbo mode allows
processor cores to run faster than marked frequency in specific condition.
Configuration options: [Disabled] [Enabled]
2.4.6 Xtreme Phase Full Power Mode [Auto]
[Auto] Automatic configuration.
[Enabled] Enables Full Power Mode to ensure the best CPU overclocking
performance.
BCLK Frequency [XXX]
This item appears when you set the AI Overclock Tuner item to [Manual], [D.O.C.P.] or
[X.M.P.] and allows you to adjust the Internal Base Clock (BCLK). Use the <+> and <-> keys
to adjust the value. You can also type the desired value using the numeric keypad. The
values range from 80 to 500.
PCIE Frequency [XXX]
This item appears only when you set the AI Overclock Tuner item to [Manual] and allows
you to set the PCI Express frequency. Use the <+> and <-> keys to adjust the PCIE
frequency. The values range from 100 to 200.
2.4.7 DRAM Frequency [Auto]
Allows you to set the DDR3 operating frequency.
Configuration options when set the AI Overclock Tuner item to [Auto] or [X.M.P.]:
[Auto] [DDR3-800MHz] [DDR3-1066MHz] [DDR3-1333MHz] [DDR3-1600]
Configuration options when set the AI Overclock Tuner item to [D.O.C.P]:
[Auto] [DDR3-900MHz] [DDR3-1200MHz] [DDR3-1500MHz] [DDR3-1800]
• The DRAM Frequency configuration options vary with the BCLK Frequency item
settings.
• According to Intel CPU spec, CPUs with a core frequency of 2.66G support the
maximum DIMM frequency of up to DDR3 1333. To use DIMMs of a higher frequency
with a 2.66G CPU, enable the DRAM O.C. Profile feature in BIOS. Refer to section
2.4.2 Ai Overclock Tuner for details.
Selecting a very high DRAM frequency may cause the system to become unstable! If this
happens, revert to the default setting.
2.4.8 QPI Frequency [Auto]
Allows you to set the QuickPath Interconnect (QPI) frequency.
Configuration options: [Auto] [4270MHz] [4800MHz]
2.4.9 ASUS/3rd Party UI Priority [ASUS Utility]
[ASUS Utility] Prioritizes the usage of ASUS utilities (ASUS EPU, TurboV EVO, etc.).
Other 3rd party OC utilities may not be full-functioned.
[3rd Party Utility] Prioritizes 3rd party OC utilities (IXTU, SetFS, etc.). ASUS utilities can’t be
launched.