Asus P5V-X SE User Manual

Page 41

ASUS P5V-X SE

1-29

2. Primary/Secondary IDE connectors

(40-1 pin PRI_IDE [blue]; 40-1 pin SEC_IDE [black])
The onboard IDE connectors are for Ultra DMA 133/100/66 signal cables.

There are three connectors on each Ultra DMA 133/100/66 signal cable:

blue, black, and gray. Connect the blue connector to the motherboard’s IDE

connector, then select one of the following modes to configure your device(s).

• Pin 20 on the IDE connector is removed to match the covered hole on the

Ultra DMA cable connector. This prevents incorrect insertion when you

connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select,” make sure all other device

jumpers have the same setting.

-X SE

P5V-X SE IDE Connectors

PRI_IDE

NOTE: Orient the red markings

(usually zigzag) on the ID

ribbon cable to PIN 1.

SEC_IDE

PIN1

Drive jumper setting

Mode of

device(s)

Cable connector

Single device

Cable-Select or Master

Black

Two devices

Cable-Select

Master

Black

Slave

Gray

Master

Black or gray

Slave