Asus P4S133-VM - Manual (Page 45)

ASUS P4S133-VM motherboard user guide 33
10. IDE Connectors (40-1 pin IDE1 / IDE2)
This connector supports the provided UltraDMA/100/66 IDE hard disk
ribbon cable. Connect the cable’s blue connector to the IDE1
(recommended) or to the IDE2 connector; then connect the gray connector
to the UltraDMA/100/66 slave device (hard disk drive) and the black
connector to the UltraDMA/100/66 master device. It is recommended
that you connect non-UltraDMA/100/66 devices to the secondary IDE
connector. If you install two hard disks, you must configure the second
drive as a slave device by setting its jumper accordingly. Refer to the
hard disk documentation for the jumper settings. BIOS supports specific
device bootup. If you have more than two UltraDMA/100/66 devices,
purchase another UltraDMA/100/66 cable. You may configure two hard
disks to be both master devices with two ribbon cables – one for the
primary IDE connector and another for the secondary IDE connector.
1. Pin 20 on each IDE connector is removed to match the covered
hole on the UltraDMA cable connector. This prevents incorrect
orientation when you connect the cables.
2. The hole near the blue connector on the UltraDMA/100/66 cable is
intentional.
For UltraDMA/100/66 IDE devices, use an 80-conductor IDE cable. The
UltraDMA/66 cable included in the motherboard package also supports
UltraDMA/100.
P4S133-VM
®
P4S133-VM IDE Connectors
NOTE: Orient the red markings
on the IDE ribbon cable to
PIN 1
Secondary IDE Connector
PIN 1
Primary IDE Connector
PIN 1