Asus MAXIMUS VI GENE - Manual (Page 107)

ASUS MAXIMUS VI GENE 3-21
Chapter 3
DMI Gen 2 [Auto]
Allows you to enable or disable DMI Gen 2. Auto means Enabled. Configuration
options: [Auto] [Enabled] [Disabled]
DMI De-emphasis Control [-6 dB]
Configure De-emphasis control on DMI. Configuration options: [-6 dB] [-3.5 db]
SATA Drive Strength [Auto]
SATA Drive Strength. Configuration options: [Auto] [��10] - [-10]
PCIE Tuning
Internal Graphics [Auto]
Keep IGD enabled based on setup options.
Configuration options: [Auto] [Disabled] [Enabled]
CPU Power Management
The subitems in this menu allow you to set the CPU ratio and features.
Enhanced Intel SpeedStep Technology [Enabled]
Allows the operating system to dynamically adjust the processor voltage and cores
frequency to decrease the average power consumption and decrease average heat
production.
Configuration options: [Enabled] [Disabled]
Turbo Mode [Enabled]
Allows you to enable your processor cores to run faster than the base operating
frequency when it is below power, current and specification limit.
Configuration options: [Disabled] [Enabled]
The following items appear only when you set the Turbo Mode to [Enabled].
Turbo Mode Parameters
Long Duration Package Power Limit [Auto]
Allows you to limit the Turbo Ratio’s time duration thay exceeds the TDP
(Thermal Design Power) for maximum performance. Use the <+> and <->
keys to adjust the value. The values range from 1W to 4096W.
Package Power Time Window [Auto]
Also known as Power Limit 1, and allows you to maintain the time window
for Turbo Ratio over TDP (Thermal Design Power). Use the <+> and <->
keys to adjust the value. The values range from 1 second to 127 seconds.
Short Duration Package Power Limit [Auto]
Also known as Power Limit 2, and allows you to provide rapid protection
when the package power exceeds the Power Limit 1. Use the <+> and <->
keys to adjust the value. The values range from 1W to 4096W.
CPU Integrated VR Current Limit [Auto]*
Allows you to set a higher current limit to prevent frequency and power
throttling when overclocking. Use the <+> and <-> keys to adjust the value.
The values range from 0.125 to 1023.875 with a 0.125 interval.