Asus P5QL-CM - Manual (Page 47)

ASUS P5QL-CM 1-35
10. USB connectors (10-1 pin USB1112, USB910, USB78)
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
The USB module is purchased separately.
9. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
P5QL-CM
P5QL-CM USB2.0 connectors
PIN 1
USB+5
V
USB_P12- USB_P12+ GND NC
USB+5V
USB_P11- USB_P11+
GND
USB1112
PIN 1
USB+5
V
USB_P10- USB_P10+ GND NC
USB+5V
USB_P9
-
USB_P9
+
GND
USB910
PIN 1
USB+5
V
USB_P8
-
USB_P8
+
GND NC
USB+5V
USB_P7
-
USB_P7
+
GND
USB78
P5QL-CM
+5VSB_M
B
Chassis Signal GN
D
CHASSIS
P5QL-CM Chassis intrusion connector