Asus K8N-E - Manual (Page 29)

ASUS K8N-E 1-19
2. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the floppy
drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables
with pin 5 plug).
K8N-E
®
K8N-E Floppy disk drive connector
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
FLOPPY
PIN 1
3. Serial ATA connectors (7-pin SATA1, SATA2)
These next generation connectors support the thin Serial ATA cables for
primary internal storage devices. The current Serial ATA interface allows up to
150 MB/s data transfer rate, faster than the standard parallel ATA with 133MB/s
(Ultra ATA/133).These connectors support two Serial ATA hard disk drives that
you can combine with the IDE connectors to configure a RAID set through the
built-in RAID controller.
K8N-E
®
K8N-E SATA connectors
SATA1
GND
RSA
T
A_TXP1
RSA
T A_TXN1
GND
RSA
T
A_RXN1
RSA
T A_RXP1
GND
SATA2
GND
RSA
T
A_TXP2
RSA
T A_TXN2
GND
RSA
T
A_RXN2
RSA
T A_RXP2
GND