Asus Maximus IV Extreme-Z - Manual (Page 128)

3-36 Chapter 3: BIOS setup
Bootup NumLock State [On]
[On] Sets the power-on state of the NumLock to [On].
[Off] Sets the power-on state of the NumLock to [Off].
Full Screen Logo [Enabled]
[Enabled] Enables the full screen logo display feature.
[Disabled] Disables the full screen logo display feature.
Set this item to [Enabled] to use the ASUS MyLogo 2™ feature.
Wait for ‘F1’ If Error [Enabled]
When set to [Enabled], the system waits for the key to be pressed when error
occurs.
Option ROM Messages [Force BIOS]
[Force BIOS] The third-party ROM messages will be forced to display during the
boot sequence.
[Keep Current] The third-party ROM messages will be displayed only if the third-
party manufacturer had set the add-on device to do so.
Setup Mode [Advanced Mode]
[Advanced Mode] Sets Advanced Mode as the default screen for entering the
BIOS setup program.
[EZ Mode] Sets EZ Mode as the default screen for entering the BIOS setup
program.
Boot Option Priorities
These items specify the boot device priority sequence from the available devices.
The number of device items that appears on the screen depends on the number of
devices installed in the system.
• To select the boot device during system startup, press when ASUS
Logo appears.
• To access Windows OS in Safe Mode, do any of the following:
- Press when ASUS Logo appears.
- Press after POST.
Boot Override
These items displays the available devices. The number of device items that
appears on the screen depends on the number of devices installed in the system.
Click an item to start booting from the selected device.