Asus P2Z-B - Manual (Page 13)

ASUS P2Z-B User’s Manual 13
III. HARDWARE SETUP
Motherboard Settings
1) KBPWR p. 14 Keyboard Power Up
2) VIO p. 15 VIO Selection
3) VCORE p. 15 Voltage Regulator Output Selection
4) FS0, FS1, FS2, FS3 p. 16 CPU External Clock (BUS) Frequency Selection
5) BF0, BF1, BF2, BF3 p. 16 CPU Core:BUS Frequency Multiple
Expansion Slots/Sockets
1) System Memory p. 18 System Memory Support
2) DIMM Sockets p. 19 DIMM Memory Module Support
3) Slot 1 p. 21 CPU Support
4) SLOT1, SLOT2 p. 26 16-bit ISA Bus Expansion Slots *
5) PCI1, PCI2, PCI3 p. 26 32-bit PCI Bus Expansion Slots
6) AGP p. 27 Accelerated Graphics Port
Hardware Monitor
1) RT2, RT3 p. 25 Thermal Sensor Connectors
Connectors
1) KB-PS2KB p. 28 Keyboard Port Connector (6-pin female)
2) FLOPPY p. 28 Floppy Disk Drive Connector (34-1 pins)
3) PARALLEL p. 29 Parallel Port Connector (25-pin female)
4) COM1, COM2 p. 29 Serial Port COM1 and COM2 Headers (9-pin male)
5) PRIMARY/SECONDARY IDE p. 30 Primary/Secondary IDE Connectors (Two 40-1pins)
6) IDELED
p. 30 IDE Activity LED Lead (2 pins)
7) CHA_, CPU_, PWR_FAN p. 31 Chassis, CPU, Power Supply Fan Connectors (Three 3-pin)
8) WOL_CON p. 31 Wake-On-LAN Connector (3 pins)
9) MSG.LED (PANEL) p. 32 System Message LED (2 pins)
10) SMI (PANEL) p. 32 SMI Switch Lead (2 pins)
11) PWR.SW (PANEL) p. 32 ATX Power & Soft-Off Switch Lead (2 pins)
12) RESET (PANEL) p. 32 Reset Switch Lead (2 pins)
13) PWR.LED (PANEL) p. 32 System Power LED Lead (3-1 pins)
14) KEYLOCK (PANEL) p. 32 Keyboard Lock Switch Lead (2 pins)
15) SPEAKER (PANEL) p. 32 System Warning Speaker Connector (4 pins)
16) USB/MIR P. 33 PS/2 Mouse/USB/IR Combo-Connector (18-1 pins)
17) IR p. 33 IrDA-Compliant Infrared Module Connector (5 pins)
18) WOR p. 34 Wake-On-Ring Connector (2 pins)
19) CHASIS p. 34 Chassis Intrusion Sensor Lead (4-1 pins)
20) SBLINK p. 35 SB-Link TM Connector (6-1 pins)
21) SMB p. 35 SMBus Connector (5-1 pins)
22) ATXPWR p. 36 ATX Power Supply Connector (20 pins)
23) PS/2 p. 36 AT Power Supply Connector (20 pins)
* The onboard hardware monitor uses the address 290H-297H so legacy ISA cards must not
use this address otherwise conflicts will occur.
Layout Contents
III. H/W SETUP