Asus WL-700gE - Manual (Page 53)

WL-700gE Wireless Router User Manual
53
When ADSL Modem "Link" light is on (not blinking), this means Internet Access
is Possible.
Restart your computer.
Reconfigure the settings for ASUS Router and please refer to the Quick Setup
Guide of the WL-700gE.
Check whether the WAN LED on the router is on or not.
Check wireless encryption settings
Check whether the computer can get the IP address or not. (via both wired
network and wireless network)
Check whether your Web browser is configured to use the local LAN,
and is not configured to use a proxy server.
If the ADSL "LINK" light blinks continuously or stays off, Internet access is not
possible - the Router is unable to establish a connection with the ADSL network.
Check that your cables are connected properly.
Disconnect the power cable from the modem, wait a few minutes, then
reconnect the cable.
If the ADSL light continues to blink or stays off, contact your ADSL
service provider.
5). Network name or encryption keys are unknown
Try to setup the wired connection for setup the wireless encryption again.
Do the hard reset to the router.
6). How to reset to defaults
The following are factory default values. These values will be present
when you first receive your ASUS Wireless Router, or if you push the
restore button on the back of the ASUS Wireless Router over 5 seconds,
or if you click the “Restore” button on the “Factory Default” page under “
Advanced Setup” in the Web Management interface.
User Name: admin Subnet Mask: 255.255.255.0
Password: admin DNS Server 1: 192.168.1.1
Enable DHCP: Yes (if plug in Wan cable) DNS Server 2: (Blank)
IP address: 192.168.1.1
SSID: default
Domain Name: (Blank)