Asus P4-P5G41 - Manual (Page 62)

4-22 Chapter 4: BIOS setup
Memory Remap Feature [Enabled]
Enables or disables the remapping of overlapped PCI memory above the total
physical memory. We recommend that you set this item to [Enabled] when you
install 4GB memory. Configuration options: [Enabled] [Disabled]
DRAM Frequency [Auto]
Selects the DRAM frequency. Configuration options: [Auto] [667 MHz] [800 MHz]
Configure DRAM Timing by SPD [Enabled]
Allows you to enable or disable configurating DRAM Timing by SPD.
Configuration options: [Enabled] [Disabled]
Initiate Graphic Adapter [PEG/IGD]
Allows you to select the primary boot device.
Configuration options: [IGD] [PEG/IGD]
IGD Graphics Mode Select [Enabled, 32MB]
Selects the amount of system memory used by the internal graphics device.
Configuration options: [Disabled] [Enabled, 32MB] [Enabled, 64MB]
[Enabled, 128MB]
DVMT Memory [256MB]
Selects the DVMT memory. Configuration options: [128MB] [256MB]
[Maximum DVMT]
Feature PAVP Lite PAVP Paranoid
Compressed video buffer is encrypted Yes Yes
HW 128-bit AES decryption Yes Yes
Protected memory (96MB reserved during boot) No Yes
Protect Audio Video Path Mode [Disabled]
Sets the Protected Audio Video Path (PAVP).
Configuration options: [Disabled] [Lite] [Paranoid]
To use the High-Bandwidth Digital Content Protection (HDCP) function, set this
option to either [Lite] or [Paranoid]. If you select Paranoid Mode, the system
reserves 96MB for playing and storing the decrypted contents. The operation
system and other programs cannot use this reserved memory, and Vista Aero
(DWM) is disabled.
The [Maximum DVMT] option only appears when you install 1GB DDR2
DIMMs into the DIMM sockets.