Asus P4-P5G41 - Manual (Page 48)

4-8 Chapter 4: BIOS setup
To update the BIOS using EZ Flash 2:
1. Download the latest BIOS file from the ASUS website at www.asus.com.
2. Save the BIOS file to a floppy disk or USB flash disk, then restart the system.
3. Launch EZ Flash 2 using either of the following methods.
4.1.4 ASUS EZ Flash 2 utility
The ASUS EZ Flash 2 feature allows you to update the BIOS without having to go
through the long process of booting from a floppy disk and using a DOS-based
utility. The EZ Flash 2 utility is built in the BIOS chip so it is accessible by pressing
+ during the Power-On Self-Test (POST).
• Insert the floppy disk / USB flash disk that contains the BIOS file to the
floppy disk drive or a USB port.
Press + during POST to display the following:
• Insert the floppy disk / USB flash disk that contains the BIOS file to the
floppy disk drive or a USB port.
Press during POST to enter the BIOS Setup utility. Go to Tools >
EZ Flash2, then press .
4. Press to locate the correct file, then press . EZ Flash 2
performs the BIOS updating process and automatically reboots the system
when done.
• This function supports USB flash disks and floppy disks with FAT 32/16
format and single partition only.
• DO NOT shut down or reset the system while updating the BIOS to prevent
system boot failure!
ASUSTek EZ Flash 2 BIOS ROM Utility V3.34
Current ROM Update ROM
A:
Note
[Enter] Select or Load [Tab] Switch [V] Drive Info
[Up/Down/Home/End] Move [B] Backup [ESC] Exit
FLASH TYPE: MXIC 25L8005
PATH: A:\
BOARD: P5Q8L P-P5G41
VER: 0209 (H:02 B:09)
DATE: 02/09/2009
BOARD: Unknown
VER: Unknown
DATE: Unknown