Asus P2L-B - Manual (Page 29)

ASUS P2L-B User’s Manual 29
III. INSTALLATION
(Connectors)
III. INST
ALLA
TION
7. CPU Cooling Fan Connectors (FAN, 3-pins)
This connector supports a 3-pin CPU cooling fan of 500mAMP (6WATT) or
less with a minimum of 3,500RPM. Depending on the fan manufacturer, the
wiring and plug may be different. The red wire should be Positive, the black
should be Ground, and the yellow wire should be Rotation signal.
WARNING! The CPU and/or motherboard will overheat if there is no airflow
across the CPU. Damage may occur to the motherboard and/or the CPU fan if
these pins are incorrectly used. These are not jumpers, do not place jumper
caps over these pins.
R
P2L-B 12Volt Cooling Fan Power
Chassis Fan Power
GND
Rotation
+12V
GND
Rotation
+12V
Power Supply Fan
CPU Fan Power
GND
Rotation
+12V
8. Wake on LAN Activity Connector (WOL_CON, 3-pins)
This connector allows the system to power up when there is a wakeup package
(signal) received from the network through the ASUS PCI-L101 LAN card. Re-
quires the ASUS PCI-L101 and an ATX power supply with at least 720mAmp
5VSB.
R
P2L-B Wake on LAN Connector
+5 Volt Standby
PME
Ground