Asus CUV4X-ME - Manual (Page 38)

38 ASUS CUV4X-ME User’s Manual
Connectors
3. H/W SETUP
3. HARDWARE SETUP
18) ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT: Make sure that your ATX power supply can supply at least 10mA
on the +5-volt standby lead (+5VSB). You may experience difficulty in power-
ing ON your system if your power supply cannot support the load. For Wake-
On-LAN support, your ATX power supply must supply at least 720mA +5VSB.
®
CUV4X-ME
CUV4X-ME ATX Power Connector
+3.3 V
olts
-12.0 V
olts
Ground Power Supply On Ground Ground Ground -5.0 V
olts
+5.0 V
olts
+5.0 V
olts
Power Good
+12.0 V
olts
+3.3 V
olts
+3.3 V
olts
Ground
+5.0 V
olts
Ground
+5.0 V
olts
Ground
+5V Standby
19) Power Supply Thermal Sensor Connector (2-pin block JTPWR)
If you have a power supply with thermal monitoring, connect its thermal sensor
cable to this connector.
CUV4X-ME Thermal Sensor Connector
JTPWR
Power Supply
Thermal Sensor
®
CUV4X-ME