Asus Z7S WS - Manual (Page 57)

ASUS Z7S WS 2-35
9.. SSI.power.connectors.(24-pin.EATXPWR,.8-pin.EATX12V,.4-pin.ATX12V)
These connectors are for SSI power supply plugs. The power supply plugs
are designed to fit these connectors in only one orientation. Find the proper
orientation and push down firmly until the connectors completely fit.
Z7S WS
®
Z7S WS ATX power connectors
8-PIN
GND
+12V
1
GND
+12V
1
GND
+12V
4
GND
+12V
4
24-PIN Power Connector
EATXPWR EATX12V
+3
Vo
lts
+3
Vo
lts
Ground +5
Vo
lts
+5
Vo
lts
Ground Ground
Power OK
+5V Standby
-5
Vo
lts
+5
Vo
lts
+3
Vo
lts
-12V3 Ground Ground Ground PSON
#
Ground +5
Vo
lts
+12V3 +12V3
+3
Vo
lts
+5
Vo
lts
Ground
ATX12V
+12V2
GND
+12V2
GND
• For a fully configured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version)
and provides a minimum power of 600 W.
• Do not forget to connect the 8-pin EATX12V power plug; otherwise, the
system will not boot.
• If you install only one CPU on the CPU0 socket, you can connect only the
EATXPWR and EATX12V power connectors to boot the system.
• Use of a PSU with a higher power output is recommended when configuring
a system with more power-consuming devices. The system may become
unstable or may not boot up if the power is inadequate.
• If you want to use two high-end PCI Express x16 cards, use a PSU with
600W power or above to ensure the system stability.
• If you are uncertain about the minimum power supply requirement for your
system, refer to the Recommended.Power.Supply.Wattage.Calculator
at http://support.asus.com/PowerSupplyCalculator/PSCalculator.
aspx?SLanguage=en-us for details.