Asus Z7S WS - Manual (Page 56)

2-34 Chapter 2: Hardware information
7.. Power.supply.SMBus.connector.(5-pin.PSUSMB1)
This connector is for the power supply SMB cable, if your power supply
supports the SMBus function.
Z7S WS Power supply SMBus connector
PSUSMB1
+3.3V
GND
NC
SMBDAT
SMBCLK
Z7S WS
®
PIN 1
8.. Chassis.intrusion.connector.(4-1.pin.CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
Z7S WS
®
Z7S WS Chassis intrusion connector
CHASSIS
+5VSB_MB
Chassis Signal
GND
(Default)