Asus M4A88TD-M EVO/USB3 - Manual (Page 71)

ASUS M4A88TD-M EVO 2-23
The following items only appear when a USB storage device is plugged in.
USB Mass Storage Device Configuration
USB Mass Storage Reset Delay [20 Sec]
Sets the maximum time that the BIOS waits for the USB storage device to initialize.
Configuration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Emulation Type [Auto]
Allows you to set the emulation type. Configuration options: [Auto] [Floppy]
[Forced FDD] [Hard Disk] [CDROM]
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2010, American Megatrends, Inc.
Suspend Mode [Auto]
ACPI 2.0 Support [Enabled]
ACPI APIC support [Enabled]
APM Configuration
HW Monitor Configuration
Anti Surge Support [Enabled]
EuP Ready [Disabled]
Select the ACPI state
used for System
Suspend.
BIOS SETUP UTILITY
Main Ai Tweaker Advanced Power Boot Tools Exit
Power Settings
2.6.1 Suspend Mode [Auto]
Selecta the Advanced Configuration and Power Interface (ACPI) state to be used for system
suspend. Configuration options: [S1 (POS) Only] [S3 Only] [Auto]
2.6.2 ACPI 2.0 Support [Enabled]
Enables or disables the Advanced Configuration and Power Interface (ACPI) 2.0 support.
Configuration options: [Disabled] [Enabled]
2.6.3 ACPI APIC Support [Enabled]
Enables or disables the Advanced Configuration and Power Interface (ACPI) support in the
Advanced Programmable Interrupt Controller (APIC). When this item is set to [Enabled], the
ACPI APIC table pointer is included in the RSDT pointer list. Configuration options: [Disabled]
[Enabled]
2.6 Power menu
The Power menu items allow you to change the settings for the Advanced Configuration and
Power Interface (ACPI) and the Advanced Power Management (APM). Select an item then
press to display the configuration options.