Asus M4A88TD-M - Manual (Page 69)

ASUS M4A88TD-M 2-25
Power on By PS/2 Keyboard [Disabled]
Enables or disables PS/2 Keyboard to generate a wake event.
Configuration options: [Disabled] [Space Bar] [Power Key] [Ctrl - Esc]
Power on From S5 By RTC Alarm [Disabled]
Enables or disables RTC to generate a wake event. Configuration options: [Disabled]
[Enabled]
2.6.5 HW Monitor Configuration
CPU / MB Temperature [xxxºC/xxxºF] or [Ignored]
The onboard hardware monitor automatically detects and displays the motherboard and CPU
temperatures. Select [Ignored] if you do not want the detected temperatures to be displayed.
CPU Fan Speed [xxxxRPM] or [Ignored] / [N/A]
Chassis Fan Speed [xxxxRPM] or [Ignored] / [N/A]
The onboard hardware monitor automatically detects and displays the CPU / Chassis fan
speeds in rotations per minute (RPM). If the fan is not connected to the motherboard, the field
shows N/A. Select [Ignored] if you do not wish to display the detected speed.
VCORE Voltage, 3.3V Voltage, 5V Voltage, 12V Voltage [xx.xxxV] or [Ignored]
The onboard hardware monitor automatically detects the voltage output through the onboard
voltage regulators. Select [Ignored] if you do not want the detected voltage to be displayed.
CPU Q-Fan Function [Enabled]
Enables or disables the CPU Q-Fan control feature. Configuration options: [Disabled]
[Enabled]
The following item appears only when you set CPU Q-Fan Function to [Enabled].
CPU Q-Fan Mode [Standard]
This item appears only when you enable the CPU Q-Fan Function feature and allows you to
set the appropriate performance level of the CPU fan.
[Standard] Sets to [Standard] to make the CPU fan automatically adjust depending on
the CPU temperature.
[Silent] Sets to [Silent] to minimize the fan speed for quiet CPU fan operation.
[Turbo] Set to [Turbo] to achieve maximum CPU fan speed.
[Manual] Allows you to individually set the CPU fan parameters.
2.6.6 Anti Surge Support [Enabled]
Enables or disables the Anti Surge support. Configuration options: [Disabled] [Enabled]
2.6.7 NB Thermal Protect [Enabled]
When this item is enabled, the system will automatically shut down when the Northbridge
temperature is over 95ºC to avoid any damage to the Northbridge chipset. Configuration
options: [Disabled] [Enabled]