Asus DSBF-D16/SAS - Manual (Page 55)

ASUS DSBF-D16 Series 2-33
4. LAN controller setting (3-pin LAN_EN1, LAN_EN3, LAN_EN4)
These jumpers allow you to enable or disable the onboard Intel ® 82563EB
Gigabit LAN controller and the onboard Intel ® 82573L Gigabit LAN controllers.
Set to pins 1-2 to activate the Gigabit LAN feature.
®
2 3 1 2
2 3 1 2
2 3 1 2
DSBF-D16 Series LAN setting
LAN_EN1
Enable
(Default)
Disable
LAN_EN3
Enable
(Default)
Disable
LAN_EN4
Enable
(Default)
Disable
5. Fan control setting (3-pin FAN_SEL1, FAN_SEL2)
These jumpers allow you to switch for fan pin selection. The FAN_SEL1
jumper is for the CPU fans control and FAN_SEL2 is for the other fans control
including front fans, rear fans and FB-DIMM fans. Set to pins 1-2 for 4-pin
fans or pins 2-3 for 3-pin fans.
®
DSBF-D16 Series VGA setting
FAN_SEL1
1 2 2 3
4-PIN FAN
(Default)
3-PIN FAN
FAN_SEL2
1 2 2 3
4-PIN FAN
(Default)
3-PIN FAN
• If you use a 4-pin fan but set the jumper to pin 2-3, the fan you installed
may not work.
• If you use a 3-pin fan but set the jumper for a 4-pin fan, the fan controll will
not work and the fan you installed will always run at full speed.
(82563EB)
(82573L)
(82573L)