Asus Terminator Tualatin - Manual (Page 59)

ASUS Terminator Barebone System 59
The following 20-pin PANEL illustration is for items 11-16.
11. System Power LED Connector (3-1 pin PWR.LED)
This 3-1 pin connector connects to the system power LED. The
LED lights up when you turn on the system power, and blinks
when the system is in sleep or soft-off mode.
12. System Warning Speaker Connector (4-pin SPEAKER)
This 4-pin connector connects to the case-mounted speaker.
13. System Message LED Connector (2-pin MSG.LED)
This 2-pin connector is for the system message LED that indicates
receipt of messages from a fax/modem. The normal status for
this LED is ON, when there is no incoming data signal. The LED
blinks when there is data received. The system message LED
feature requires an ACPI OS and driver support.
14. System Management Interrupt Connector (2-pin SMI)
This 2-pin connector allows you to manually place the system
into a suspend mode, or “Green” mode, where system activity is
instantly decreased to save power and to expand the life of certain
system components. Attach the case-mounted suspend switch
this 2-pin connector.
15. ATX Power Switch / Soft-Off Switch Connector (2-pin
PWR.SW)
The system power is controlled by a momentary switch attached
to this connector. Pressing the button switches the system
between ON and SLEEP, or ON and SOFT OFF, depending on
the BIOS or OS settings. Pressing the button while in the ON
mode for more than 4 seconds turns the system off.
16. Reset Switch Connector (2-pin RESET)
This 2-pin connector connects to the case-mounted reset switch
for rebooting the system without turning off the power switch.
TUSC
®
TUSC System Panel Connectors
* Requires an ATX power supply.
PLED
Ground
TB_LED
PWR
+5 V
+5V
Speaker Ground
+5 V
ExtSMI#
Ground
Reset
Ground
Ground
Power LED
Speaker
Connector
Message LED
SMI Lead
Reset SW
ATX Power
Switch*