Asus CUR-DLSR - Manual (Page 50)

ASUS CUR-DLSR User’s Manual 50
4. BIOS SETUP
4. BIOS SETUP
Master/Slave Devices
[User Type HDD]
Manually enter the number of cylinders, heads and sectors per track for
your drive. Refer to your drive documentation or look on the drive for this
information. If no drive is installed or if you are removing a drive and not
replacing it, select [None].
Translation Method [LBA]
Select the hard disk drive type in this field. When Logical Block Addressing
is enabled, 28-bit addressing of the hard drive is used without regard for
cylinders, heads, or sectors. Note that LBA Mode is necessary for drives
with greater than 504MB in storage capacity. Configuration options: [LBA]
[LARGE] [Normal] [Match Partition Table] [Manual]
Cylinders
This field configures the number of cylinders. Refer to your drive
documentation to determine the correct value to enter into this field. NOTE:
To make changes to this field, the Type field must be set to [User Type
HDD] and the Translation Method field must be set to [Manual].
IMPORTANT: If the hard disk was already formatted on an older system, Setup may
detect incorrect parameters. You will need to enter the correct parameters manually,
or use low-level format in case you do not need the data stored on the hard disk. If the
parameters listed differ from the ones used when the disk was formatted, the disk
will not be readable. If the auto-detected parameters do not match the ones that
should be used for the disk, you should enter the correct ones manually by setting
[User Type HDD].