Hardware setup – Asus CUR-DLSR User Manual

Page 30

3. HARDWARE SETUP

ASUS CUR-DLSR User’s Manual

3. H/W SETUP

Connectors

2) Primary/Secondary IDE Connectors (40-1 pin IDE1/IDE2)

These connectors support UltraDMA/33 IDE hard disks. Use IDE ribbon cables
to connect the master and slave devices to these connectors. If you install two
hard disks, you must configure the second drive as a slave device by setting its
jumper accordingly. Refer to the hard disk documentation for the jumper settings.
BIOS supports specific device bootup (see 4.6. Boot Menu).

NOTE: Pin 20 on each IDE connector is removed to match the covered hole
on the UltraDMA cable connector. This prevents incorrect orientation when
you connect the cables.

TIP: You may configure two hard disks to be both Masters with two ribbon
cables – one for the primary IDE connector and another for the secondary
IDE connector.

CUR-DLSR

CUR-DLSR IDE Connectors

NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.

IDE2

IDE1

PIN 1