Asus P5LD2 User Manual

Page 45

A S U S P 5 L D 2

2 - 2 3

2.7.2

Internal connectors

1 .

F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y )

F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y )
This connector is for the provided floppy disk drive (FDD) signal cable.
Insert one end of the cable to this connector, then connect the other
end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection
when using a FDD cable with a covered Pin 5.

P5LD2

NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.

P5LD2 Floppy disk drive connector

PIN 1

FLOPPY

2 .

ITE IDE connectors (40-1 pin PRI_EIDE [red], SEC_EIDE [red])

ITE IDE connectors (40-1 pin PRI_EIDE [red], SEC_EIDE [red])
These connectors are for Ultra ATA 133/100/66 signal cables. The
ITE IDE connectors support up to four IDE hard disk drives for easier
data storage and data transfer.

P5LD2

P5LD2 RAID connectors

NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.

PRI_EIDE

SEC_EIDE

PIN 1

•

Make sure that you install the I T E 8 2 1 1 I D E D r i v e r

I T E 8 2 1 1 I D E D r i v e r

I T E 8 2 1 1 I D E D r i v e r from the

support CD before using the IDE device attached to any of these
connectors. See Chapter 5 for details.

•

These connectors do not support ATAPI devices.