Asus P5LD2 - Manual (Page 129)

A S U S P 5 L D 2 A S U S P 5 L D 2 A S U S P 5 L D 2 A S U S P 5 L D 2 A S U S P 5 L D 2 5 - 2 5 5 - 2 5 5 - 2 5 5 - 2 5 5 - 2 5
4. The Disks item is highlighted, press to select the hard disk
drives to configure as RAID. The following pop-up screen appears.
[ SELECT DISKS ]
[ ↑↓ ↑↓ ↑↓ ↑↓ ↑↓]-Previous/Next [SPACE]-Selects [ENTER]-Selection Complete
Port Drive Model Serial # Size Status
0 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
1 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
2 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
3 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
Select 2 to 4 disks to use in creating the volume.
5. Use the up/down arrow key to highlight the drive you want to set,
then press to select. A small triangle marks the selected
drive. Press after completing your selection.
6. When the S t r i p e S i z e S t r i p e S i z e S t r i p e S i z e S t r i p e S i z e S t r i p e S i z e item is highlighted, press the up/down arrow
key to select the stripe size for the RAID 5 array, then press .
The available stripe size values range from 4 KB to 128 KB. The
default stripe size is 64 KB.
T I P : T I P : T I P : T I P : T I P : We recommend a lower stripe size for server systems, and a higher
stripe size for multimedia computer systems used mainly for audio and
video editing.
7. Key in the RAID volume capacity that you want, then press
when the C a p a c i t y
C a p a c i t y C a p a c i t y C a p a c i t y C a p a c i t y item is highlighted. The default value indicates
the maximum allowed capacity.
8. Press when the C r e a t e V o l u m e C r e a t e V o l u m e C r e a t e V o l u m e C r e a t e V o l u m e C r e a t e V o l u m e item is highlighted. This
warning message appears.
WARNING: ALL DATA ON SELECTED DISKS WILL BE LOST.
Are you sure you want to create this volume? (Y/N):
9. Press to create the RAID volume and return to the main menu or
to go back to the Create Volume menu.