Asus M5A88-M EVO - Manual (Page 71)

ASUS M5A88-M EVO 2-23
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2010, American Megatrends, Inc.
Suspend Mode [Auto]
ACPI 2.0 Support [Enabled]
ACPI APIC support [Enabled]
APM Configuration
HW Monitor Configuration
Anti Surge Support [Enabled]
NB Thermal Protect [Enabled]
Select the ACPI state
used for System
Suspend.
M5A88-M EVO BIOS Setup
Main Ai Tweaker Advanced Power Boot Tools Exit
Power Settings
2.6.1 Suspend Mode [Auto]
Selecta the Advanced Configuration and Power Interface (ACPI) state to be used for system
suspend. Configuration options: [S1 (POS) Only] [S3 Only] [Auto]
2.6.2 ACPI 2.0 Support [Enabled]
Enables or disables the Advanced Configuration and Power Interface (ACPI) 2.0 support.
Configuration options: [Disabled] [Enabled]
2.6.3 ACPI APIC Support [Enabled]
Enables or disables the Advanced Configuration and Power Interface (ACPI) support in the
Advanced Programmable Interrupt Controller (APIC). When this item is set to [Enabled], the
ACPI APIC table pointer is included in the RSDT pointer list. Configuration options: [Disabled]
[Enabled]
2.6.4 APM Configuration
Restore on AC Power Loss [Power Off]
When this item set to [Power Off], the system goes into off state after an AC power loss.
When this item set to [Power On], the system goes on after an AC power loss. When this
item set to [Last State], the system goes into either off or on state, whatever the system
state was before the AC power loss. Configuration options: [Power Off] [Power On] [Last
State]
Power on From S5 By PME# [Disabled]
Enables or disables PME wake from sleep states. Configuration options: [Disabled] [Enabled]
Power on From S5 By Ring [Disabled]
Enables or disables ring to generate a wake event. Configuration options: [Disabled]
[Enabled]
2.6 Power menu
The Power menu items allow you to change the settings for the Advanced Configuration and
Power Interface (ACPI) and the Advanced Power Management (APM). Select an item then
press to display the configuration options.
Version 0203