Asus M4A89TD PRO/USB3 - Manual (Page 46)

2-28 Chapter 2: Hardware information
Chapter 2
2. AMD ® SB850 Serial ATA Serial ATA 6.0 Gb/s connectors (7-pin SATA 1-6)
These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA hard disk
drives and optical disc drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, RAID 5,
or RAID 10 configuration through the onboard AMD ® SB850 controller.
• These connectors are set to IDE mode by default. In IDE mode, you can connect
Serial ATA boot/data hard disk drives to these connectors. If you intend to create a
Serial ATA RAID set using these connectors, set the SATA Port1-Port4 item or SATA
Port5-Port6 item in the BIOS to [RAID]. See section 3.4.2 Storage Configuration for
details.
• You must install Windows ® XP Service Pack 2 or later version before using Serial
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows ® XP SP2 or later version.
• When using hot-plug and NCQ, set the SATA Port1-Port4 in the BIOS to [AHCI]. See
section 3.4.2 Storage Configuration for details.