beautypg.com

Chapter - software reference – Asus USB-N11 User Manual

Page 21

background image

ASUS WLAN Adapter

21

Chapter - Software Reference

Chapter

So

ftw

ar

e

Re

fe

re

nc

e

Data encryption

For Open and Shared authentication mode, the configuration options of

encryption type are Disabled and WEP. For WPA, WPA-PSK, WPA2 and

WPA2-PSK authentication mode, Temporal Key Integrity Protocol (TKIP)

encryption and Advanced Encryption Standard (AES) encryption are supported.
Disabled - Disable the encryption function.
WEP - WEP Key is used to encrypt your data before it is transmitted over air.

You can only connect and communicate with wireless devices that use the

same WEP keys.
TKIP - TKIP uses an encryption algorithm method that is more stringent than

the WEP algorithm. It also uses existing WLAN calculation facilities to perform

encryption. TKIP verifies the security configuration after the encryption keys are

determined.
AES: AES is a symmetric 128-bit block encryption technique that works

simultaneously on multiple network layers.

Wireless Network Key

This option is enabled only if you select WPA-PSK or WPA2-PSK authentication

mode. Select “TKIP” or “AES” in the encryption filed as encryption mode to

begin the encryption proceed. Note: 8 to 64 characters are required in this field.

Wireless Network Key (WEP)

This option is configurable only if you enable WEP in Network Authentication

field. The WEP Key is a 64 bits (5 byte) or 128 bits (13 byte) Hexadecimal

digits which is used to encrypt and decrypt data packets.

Key Format

You can select to enter Hexadecimal digits (0~9, a~f, and A~F) or ASCII

characters to setup keys by defining the Key Format.

Key Length

For 64 bits encryption, each key contains 10 hex digits or 5 ASCII characters.

For 128 bits encryption, each key contains 26 hex digits or 13 ASCII characters.

Manual assign WEP keys - When you select this option, the cursor appears

in the field for Key 1. For 64-bit encryption, you are required to enter four WEP

Keys. Each Key contains exactly 10 hex digits (0~9, a~f, and A~F). For 128-bit

encryption, you are required to enter four WEP Keys. Each Key contains

exactly 26 hex digits (0~9, a~f, and A~F).